Fault - Cause - Remedy - Dräger Babylog 8000 Gebrauchsanweisung

Fault – Cause – Remedy
Fault – Cause – Remedy
Fault
Display
»Printer inop«
No signal on
analogue or pulse
output.
No data transmission to
monitor.
28
Cause
Printer switched off.
No Paper.
Faulty cable.
RS 232 interface of Babylog
or printer not properly confi-
gured.
Faulty cable.
Fault in interface.
Faulty monitor cable.
RS 232 interface of Babylog
or monitor not properly
configured.
Fault in interface.
Remedy
Switch on printer.
Load paper.
Replace cable.
Configure RS 232 interface
on printer to match that on
Babylog 8000.
Replace cable.
Call DrägerService.
Replace cable.
Configure RS 232 interface
on monitor to match that on
Babylog 8000.
Call DrägerService.