Ingersoll-Rand 325B Technische Produktdaten Seite 3

Product Safety Information
Intended Use:
It is designed to cut mild steel, aluminum, tin and other materials up to 18 gauge (1.2 mm).
For additional information refer to Product Safety Information Manual Form 04580494.
Manuals can be downloaded from www.ingersollrandproducts.com.
Product Specifi cations
Free
Speed
Model
Strokes/min.
325B 4200
† K = 3dB measurement Uncertainty
pA
‡ K = 3dB measurement Uncertainty
wA
* K = Vibration measurement Uncertainty
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air fi lter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off , to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16578551 and table on page 2. Maintenance frequency is shown in a circular
arrow and defi ned as h=hours, d=days, and m=months of actual use. Items identifi ed as:
1. Air fi lter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi ce or Distributor.
46806519_ed3
Max. Material
Thickness
Gauge/Inch/mm † Pressure (L
18/.05/1.2
6.
7.
8.
9.
10. Grease - during assembly
Sound Level dB (A)
(ISO15744)
) ‡ Power (L
p
96 107
Thread size
Coupling
Safety Air Fuse
Oil
EN
Vibration (m/s2)
(ISO28927)
) Level *K
w
15.9 1.9
EN-1