Cuckoo CR-0631F Bedienungsanleitung Seite 25

TO KEEP COOKED RICE WARM AND TASTY
How to Adjust the Warm Temperature
▶ If an odor develops, water drops are formed or the cooked rice is discolored
despite frequent cleaning and the use of sterilized water. The warm temperature
may be incorrect. Adjust the temperature.
❶ Press the "Keep Warm" button in
Keep Warm or Standby mode at
length over 5 sec. The display is
changed and a buzzer sounds as
shown in the above figure. In the
figure, means the current
warm temperature.
※
The factory setting temperature may be different from that of
this manual.
To adjust the warm temperature while keeping rice warm, press the "Keep Warm" button for over 5 seconds and adjust
the warm temperature.
1. A stale smell develops and lots of water drops are formed: The warm temperature is low. Raise the temperature by 1 ~ 2℃.
2. The cooked rice turns yellow, the rice gets dry and an odor develops: The warm temperature is high. Lower the temperature by 1 ~ 2℃.
How to adjeut the Customized Warm function
This function is used in case that water runs when you open the lid while keeping warm or the
cooked rice is swelled up.
❶ Press the "Keep Warm/Reheat"
button in My mode.
The display part is changed and a
buzzer sounds as shown in the
above figure. In the figure, '
means the default value.
1. If plenty of water runs out when you open the lid:
2. If the cooked rice is swollen around the edge of the rice:
'
Press the "Hrs" button to raise the setting mode by 1 or 2 stages.
Press the "Min/My mode" button to lower the setting mode by 1 or 2 stages.
❷-❶ Press the "Hrs" button to change
the display part in turn of
❸ After setting the desired temperature,
press the "Cook, Keep Warm" and "Timer"
buttons to automatically enter the value. At
this time a buzzer sounds.
If you press the Cancel button or
7 seconds flow with no input, the function
is cancelled and the mode returns to
Standby mode.
❷-❷
Press the "Min" button to
change the display in turn of
❷-❶ Press the "Hrs" button to
change the display part in turn of
❸ After setting the desired value,
press the "Cook/Turbo" button to
automatically enter the value. At
this time a buzzer sounds.
If you press the "Cancel" button
or 7 seconds pass with no input,
the function is cancelled and the
mode returns to Standby mode.
❷-❷ Press the "Min/My mode" button to
change the display part in turn of
25