Time Programming Function; To Switch A Cooking Zone Off Automatically; Automatic Timer; The Timer - Bosch PIA6-T1-Serie Montageanleitung

Time programming function

This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■

To switch a cooking zone off automatically

Enter the cooking time for the required hotplate. It will turn off
automatically when the time has lapsed.
Programming
1. Select the required power level.
0
Press the symbol. The
2. ‹‹
up. appears in the time program function display. To
select a hotplate, press the
x
indicator for the required hotplate lights up.
Press the + or - symbol of the time program function.
3.
The basic setting appears:
+ symbol: 30 minutes.
- symbol: 10 minutes.

Press the + or - symbol until the required cooking time
4.
appears.
After a few seconds, the timer will start to count down.
Once the time has elapsed
The hotplate switches off. The warning signal sounds, and the
in the time program function visual display
x
seconds. The indicator lights up on the hotplate display.
0
Pressing the symbol turns off the indicators and stops the
beep.
Changing or cancelling the time
0
Press the symbol several times until the required
indicator lights up. Change the cooking time using the + or -
‹‹
symbols, or set to .

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
28
x
indicator of the hotplate lights
0
symbol several times until the

‹‹
appears for 10
x
"
Notes
If a cooking time has been programmed in several zones, it
■
can be set to display all time values. To do this, press the
symbol several times until the
hotplate lights up.
Cooking times of up to 99 minutes can be programmed.
■

Automatic timer

With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time of a zone may be cancelled or
changed:
0
Press the
indicator lights up. Change the cooking time using the + or -
symbols, or set to

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
0
Press the ‹‹
1.
up. appears in the time program function display.
Press the + or - symbol on the time program function.
2.
The basic setting will appear.
+ symbol: 10 minutes.
- symbol: 05 minutes.
Set the time required using the + or - symbols.
3.
After a few seconds, the timer will start to count down.
Once the time has elapsed
A warning beep sounds. In the time program function display
‹‹
is shown, and the
the indicators turn off.
Pressing the
beep.
Changing or cancelling the time
0
Press the
up. Change the cooking time or set to
symbols + or -,
‰
and
x
indicator for the required
symbol several times until the required
‹‹
.
symbol several times until the
W
indicator comes on. After 10 seconds
0
symbol turns off the indicators and stops the
symbol several times until the ‹‹
0
x
W
indicator lights
W
indicator lights
with the