Quick Installation; Program Sort; Program Name - Philips 29PT864012 Bedienungsanleitung

Quick installation

When you turn on the TV set for the first
time, a menu is displayed on screen.
This menu prompts you to select the country
and language for the menus :
If the menu is not displayed, press and hold down
the
5 seconds to display the menu.
& Use the <> cursor on the remote control to
select your country and validate with ≥.
If your country does not appear in the list, select
choice ". . . "
é Next select your language using the <>
cursor and validate with ≥.

Program sort

& Press key
the screen.

Program name

If required, you can give a name to the
programmes and external connectors.
Note : on installation, the programs are named
automatically when an identification signal is sent.
& Press the
é With the cursor, select the
Name.
" Use the
programme to name or rename.
4
Downloaded from www.Manualslib.com
Main •
Install •
DK
Country •
GB English
F French
DE Deutsch
SF ...
...
" "
- and + keys on the TV set for
H
.The is displayed on
Main menu
Main •
Install •
Language •
Country •
00
Auto Store •
01 BBC1
Manuel Store • 02 BBC2
03 Æ ANGLI
Sort •
04 CH4
Program •
05 CH5
Name •
H
key.
Install
@ #
keys to select the
P
manuals search engine
" The search starts automatically.All the
available TV programmes will be stored.
This operation takes a few minutes.
The display shows the progress of the search
and the number of programs found. At the
end of the search, the menu disappears.
To exit or interrupt the search, press
programme is found, consult the possible solutions p. 12.
' If the transmitter or cable network sends the
automatic sort signal, the programs will be
numbered correctly. In this case, the
installation is complete.
( If this is not the case, you need to use the
menu to number the programs correctly.
Some transmitters or cable networks broadcast
their own sort parameters (region, language, etc.).
In this case, indicate your choice using the <>
cursor and validate with ≥.
é With the cursor, select the
followed by the
" Select the programme you want to move using
the <> cursor and press ≥.
' Then use the <> cursor to select the new
number and validate with ≤.
( Repeat steps " and ' for each program you
wish to renumber.
§ To quit the menus, press
' Use the ≤≥ cursor to move around the
name display area (5 characters) and the <>
cursor to select the characters.
( When the name has been entered, use the
key to exit.The name is stored.
menu, then
§ Repeat steps " to ( for each programme
you wish to name.
è To quit the menus, press
H
. If no
Sort
menu
Install
menu.
Sort
d
.
H
d
.