PSC Magellan 8100 Kurzanleitung Seite 11

Quick Reference Guide
Downloaded from www.Manualslib.com
PRESS
DURATION
Hold, then
release when the Increments tone
beeper sounds
Scanner Diagnostics
4 Seconds
Mode
8 Seconds
Resets Scanner
a. By standard default, this function is normally disabled to prevent accidental activation
by users.
b. Users should not perform scanner resets except under the direction of trained sys-
tems support personnel.
Productivity Index Reporting Option
optional Productivity Index Reporting™ feature. This feature allows for data
collection on the readability index of bar codes scanned by the scanner. This
data may be transmitted to the POS Terminal where it may be easily sorted for
action by the MIS department to improve bar code quality at the front end.
For additional information on how to enable Productivity Index Reporting in
your scanner, please refer to the Product Reference Guide (PRG).
manuals search engine
FUNCTION
Press the push button for approximately 2 sec-
onds, then release. Each time this is done, the
beeper will sound at one of three tones. Stop
when the desired tone (high, medium or low)
is sounded.
This mode allows system support personnel to
troubleshoot problems with the scanner. Press
the button for eight seconds or cycle power to
a
exit Scanner Diagnostics Mode and reset the
scanner.
Only system support personnel should per-
b
form a reset.
—Your 8200 scanner may be equipped with the
COMMENT
5