Raco 12155 Bedienungsanleitung

TRAILER LIGHT TESTER 12155
User guide
Automatic fuse
Charge plug
Charger
State of battery
Charging of battery:
Connect the cable with DC plug from the charger to the trailer light tester.
Plug the charger into a main socket and the voltage switch to "12V".
The green LED indicates the charging process. When the green LED turns off the battery is full
charged and the trailer light tester is ready for use.
Test of trailer:
Remove the plug from the charger and turn on the tester with the upper function switch.
When Red Button Akku Test is pressed down the 3 LEDs Shows the state of the battery.
Connect the plug from the trailer to the 13-pol socket.
The functions switches select which lamps are to be tested.
The 3 lower functions switches each have 2 functions.
The LEDs on the right indicate which lights are selected.
By short circuit, the Automatic fuse switches off and everything turns off.
Remove the load and activate the Automatic fuse. Then the tester works again.
Automatic function switch:
The top function switch is tilted to the left and the outputs change automatically. Legs 9 and 10
are not included in automation.
Specifications:
Output voltage: 12,6 V.
Max. Total power: 8 Amp.
Operating time with fully charged battery: approx. 3 hours (with 1 output enabled).
Automatic function switch
On
13 pol socket
Function switches
Akku Test
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk
Trailerlystester
/ Off
12155
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk