Raco 12152 Bedienungsanleitung

TRAILER LIGHT TESTER 12152
User guide
Charge plug
Charger
7 pol socket
State of battery
Charging of battery:
Connect the cable with DC plug from the charger to the trailer light tester.
Plug the charger into a main socket and the voltage switch to "12V".
The green LED indicates the charging process. When the green LED turns off the
battery is full charged and the trailer light tester is ready for use.
Test of trailer:
Remove the plug from the charger and turn on the tester with the upper function switch.
When Red Button "Test" is pressed down the 3 LEDs Shows the state of the battery.
Connect the plug from the trailer to the 7 or 13 pol socket.
The functions switches select which lamps are to be tested.
The 3 lower functions switches each have 2 functions.
The LEDs on the right indicate which lights are selected.
By short circuit, the Automatic fuse switches off and everything turns off.
Remove the load and activate the Automatic fuse. Then the tester works again.
Specifications:
Output voltage: 12,6 V.
Max. Total power: 8 Amp.
Operating time with fully charged battery: approx. 3 hours (with 1 output enabled).
ON / Off
Automatic fuse
13 pol socket
Akku Test
Function switches
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk
Trailerlystester
12152
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk