Raco 12156 Bedienungsanleitung

TRAILER LIGHT TESTER 12156
User guide
Charge plug
Charger
7 pol socket
State of battery
Charging of battery:
Connect the cable with DC plug from the charger to the trailer light tester.
Plug the charger into a main socket and the voltage switch to "12V".
The green LED indicates the charging process. When the green LED turns off the battery is full
charged and the trailer light tester is ready for use.
Test of trailer:
Remove the plug from the charger and turn on the tester with the upper function switch.
When Red Button "Test" is pressed down the 3 LEDs Shows the state of the battery.
Connect the plug from the trailer to the 7 or 13 pol socket.
The functions switches select which lamps are to be tested.
The 3 lower functions switches each have 2 functions.
The LEDs on the right indicate which lights are selected.
By short circuit, the Automatic fuse switches off and everything turns off.
Remove the load and activate the Automatic fuse. Then the tester works again.
Automatic function switch:
The top function switch is tilted to the left and the outputs change automatically. Legs 9 and 10
are not included in automation.
Specifications:
Output voltage: 12,6 V.
Max. Total power: 8 Amp.
Operating time with fully charged battery: approx. 3 hours (with 1 output enabled).
Automatic fuse
Automatic function switch
ON / Off
13 pol socket
Akku Test
Function switches
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk
Trailerlystester
12156
RACO A/S
Overgade 4
DK 6670 Holsted
Tlf. +45 69106680
E-mail: info@raco.dk
Web: www.raco.dk