Adjustment Works Prior To Operation; Angle Settings - HOLZMANN-MASCHINEN KAP 305JL Bedienungsanleitung

3.4 ADJUSTMENT WORKS PRIOR TO OPERATION

NEVER FORGET: Switch the machine off (38) and disconnect the machine prior
to any adjustment, maintenance or check activities from the power supply.
This prevents the hazard of unintended starting-up.

3.4.1 Angle settings

Tilt adjustment:
Loosen the fixing knob (18).
Set the saw arm in order that the tilt angle indicator (36) points exactly at 0° of the
measuring scale (19).
Fix the saw arm in this position by tightening the fixing knob (18).
Bring the saw arm into the lower position and lock it with the interlock knob (23).
Attach an exact angle measuring device to saw blade side and ground plate. They should
have an exact angle of 90°.
If not, then you need to adjust the 0° of the saw arm by adjusting it with the saw arm ad-
justment screws (N - 37).
Repeat the procedure until 0° on indicator is exactly 90° between saw blade and ground
plate.
Swing angle adjustment:
Loosen the fixing knob (3), operate the fixing lever (4) and swing the saw arm aggregate
to the 0° position, let it click into place. You can see the angle at the measuring scale (5).
Swing the saw arm into the lower position and lock it with the interlock knob (23).
Attach an exact angle measuring device to saw blade side and the left back fence (1).
They should have an exact angle of 90°.
If not, you need to adjust the back fence guide with the back fence adjustment screws
(20) so that angle between saw blade and fence equals 90°.
Repeat the procedure with the right side back fence.
Adjust the cutting depth
Finally you need to check the cutting depth of the saw.
Swing the saw arm down into lowest possible position and
check if it touches the ground plate.
The depth stop should be already preset so that the blade
reaches into the cutting line slit (2) but has a distance to the
ground plate of at least 5mm.
If necessary adjust the depth stop pin (27).
Laser
The Laser marks the cutting line. After having set all angles and
cutting depth, you should fine-tune your laser.
Attach the workpiece to the back fence, fix it with the downholder.
Perform a slot cut on the workpiece so that it gets not cut through entirely.
(See point 5, Slot cut adjustments see point 5.3.3)
Now turn on the laser (ON/OFF Switch at battery box) and check if the laser beam marks ex-
actly the real cutting line.
HOLZMANN Maschinen Austria
Zug-, Kapp-, Gehrungssäge / Profi mitre saw / PIŁA DO CIĘCIA WZDŁUŻNEGO,POPRZECZNEGO I UKOŚNEGO
www.holzmann-maschinen.at
INITIAL OPERATION
Seite 31
KAP 305JL