HANSGROHE PuraVida serie Gebrauchsanleitung, Montageanleitung Seite 3

6 6
6Safety6Notes
6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The shower system may only be used for bathing,
hygienic and body cleansing purposes.
6 The hot and cold supplies must be of equal pres-
sures.
Installation6Instructions
• The fitting must be installed, flushed and tested after
the valid norms.
• If the water is flowing along the fixture in the direction
of the shaft, the spray former must be replaced with a
standard air bubbler 13913000.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart®
(flow limiter) located behind the aerator can be
removed.
Technical6Data
This6mixer6series-produced6with6EcoSmart®6
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
English
Symbol6description
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly6see6page65
Do not use silicone containing acetic acid!
Dimensions6(see page 8)
Flow6diagram6
(see page 8)

with EcoSmart®

without EcoSmart®
Spare6parts6(see page 9)
Special6accessories
Installation kit order as an extra
Operation6(see page 11)
Cleaning6recommendation6(see
page 10) and enlosed brochure
3