Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
Make sure you have put 6pcs 1.5V batteries into the battery
chamber. Oxyride batteries are not recommended because of
the initial 1.7 Volt output. If the 1.5V battery runs out of power,
screen will show "REPLACE INTERNAL BATTERY" or" POWER
LOW". Replace those 6pcs 1.5V batteries before starting the test.
Note that nothing will be seen on the display until the tester is
connected to a vehicle battery.
3.
Make sure the battery terminals are clean. Wire brush them if
necessary. Clamp the black load lead to the vehicle negative
battery terminal. Clamp the red load lead to the vehicle positive
battery terminal. Please clamp on the lead part of the terminal
only. Clamping on the iron part of the terminal will lead to wrong
test results.
Paper load:
a.
Open the clear cover.
b.
Place a new paper roll in the compartment.
c.
Put a short length of paper from the
compartment and press down the clear
cover to close.
-
-
4
Werbung
Inhaltsverzeichnis
