Y-Volution NEON CRUIZER Bedienungsanleitung Seite 5

CARING FOR YOUR CRUZER
1. After you have used the CRUZER for a week or two, the wheels will need to bechecked to ensure they
are still in perfect working order. To do so, rotate the wheels and check the bearings for any lubrication
or adjustment that may be needed.
2. The hardness of the rear truck may be adjusted by tightening or loosening the 13mm nut. This adjusts
the truck's pre-load and will affect turning sensitivity. Heavier riders may also wish to adjust pre-load to
increase board stability.
3. Please do not use solvents on your CRUZER. They may erode the PU bushing and wheels and can also
damage the deck. To clean your CRUZER, only use hot soapy water and a stiff brush or sponge. Do not
submerge the wheel bearings in water as this may remove wheel bearing lubricant.
4. Do not leave your CRUZER outdoors for long periods of time as continued exposure to the elements
can cause the components to degrade.
5. Periodically check that all of the nuts, bolts and screws are adequately tightened and have not loos-
ened during use. Do not over-tighten.
6. Periodically lubricate the wheel bearings.
EN
7. Due to normal wear and tear the PU wheels and bearings may need to be replaced
after some time. Please contact the place of purchase for new wheels. DO NOT use parts designed for
other products, the use of anything other than CRUZER parts may affect your safety.
8. The self-locking nuts and other self-locking elements can lose their effectiveness if released.
9. Check that the steering mechanism is correctly adjusted and that the connective components are firmly
secured and not broken.
10. Ensure bearings are well-greased and free from dirt/debris before use.
11. Wheels/cushions wear over time due to normal use. Replace when necessary.
12. The hardness of the rear truck may be adjusted by tightening or loosening the nut. This adjusts the
truck's pre-load and will affect turning sensitivity. Heavier riders may also wish to adjust pre-load to
increase board stability.
13. Remove any sharp edges that may occur through use.
14. Look for splinters/cracks in the deck and replace when needed.
NOTE:
Please read this manual carefully and keep it for future reference. The dealer will not take
responsibility if the skateboard is used in a manner for which is was not intended or if all warnings which
are stated in the manual are not followed.
IMPORTANT NOTICE TO PARENTS:
This manual contains important information relating to your child's safety, it is your responsibility to
review this information with your child and make sure they are fully aware of all the information and
warnings within the manual. Please carefully read this manual before you start using the CRUZER and
review this information with young riders before they ride.