Electrolysis Cell; Installation Procedure - Swim & Fun Easy Salt 50/80 m2 Handbuch

UK

3.2. Electrolysis cell

Exploded view of the cell.
Collar
Nut
Cell sleeve
Gasket
Types of possibles assemblies:
1) Horizontal
2) Vertical mounting.
3) Bypass mounting.
1) 2)
4) T cell mounting
3) 4)
4.

INSTALLATION PROCEDURE

Switch off the filtration system.
Dismantle the cell's collars in order to measure the sleeve length and mark the location of the cell
on the pipe. It must be placed after any other treatment, cleaning or heating device (just before dis-
charge).
Cut the pipe so as to obtain a dimension equal to the size of the sleeve + 10 mm.
If the pipe diameter is 63, put the nut on the pipe and then glue the collar on the pipe. Repeat for
each side of the cut ensuring that the remaining opening is the size of the cell's sleeve.
MV-1812-1813-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
55