IKA color squid Betriebsanleitung Seite 12

• When using PTFE-coated magnetic bars, the
following has to be noted: Chemical reactions of
PTFE occur in contact with molten or solute alkali
metals and alkaline earth metals, as well as with
fine powders of metals in groups 2 and 3 of the
periodic system at temperatures above 300 °C –
400 °C. Only elementary fluorine, chlorotrifluoride
and alkali metals attack it; halogenated
hydrocarbons have a reversible swelling effect.
(Source: Römpps Chemie-Lexikon and "Ulmann", Volume
19)
/// Procedures during sample runs
• Wear your personal protective equipment in
accordance with the hazard category of the media
to be processed. There may be a risk from:
- splashing and evaporation of liquids,
- ejection of parts,
- release of toxic or combustible gases.
• Reduce speed if:
- medium splashes out of vessel because the
speed is too high,
- device is not running smoothly,
- container moves on the base plate.
12
/// Accessories
• Safe operation is guaranteed only with the use of
original IKA accessories.
• The centre of gravity of the assembly must lie with-
in the surface on which it is set up.
/// Power supply / Switching off the device
• The device will automatically restart following any
interruption to the power supply.
• The voltage stated on the type plate must corre-
spond to the mains voltage.
• The outlet for the mains plug must be easily acces-
sible.
• The device can only be disconnected from the
mains outlet by pulling out the power cord set or
the connector plug.
/// For protection of the equipment
• Attention! Device may not be poured over with
aggressive media! Never put the device under
water!
• Protect the device and accessories from bumps and
impacts.
• Keep the base plate clean.