Maintenance + Battery Replacement - Weidmuller 1037 Bedienungsanleitung

Low battery
indication:
Auto power off:
Measurement rate:
Operating
environment:
Storage temperature: 20°C to 60°C, 0 to 80% R.H. with
Accuracy:
Temperature
coefficient:
Altitude:
Power:
Battery life:
Dimensions:
Weight:
Accessories:

Maintenance + battery replacement

Maintenance consists of periodic cleaning and battery re-
placement. The exterior of the instrument can be cleaned
with a dry clean cloth to remove any oil, grease or grime.
Never use liquid solvents or detergents.
WARNING
TO AVOID ELECTRICAL SHOCK, DISCONNECT THE TEST
LEADS AND ANY INPUT SIGNALS BEFORE REPLACING
THE BATTERY. REPLACE ONLY WITH SAME TYPE OF BAT-
TERY.
This meter is powered by a NEDA type 1604 or equivalent
9-volt battery. When the meter displays the
must be replaced to maintain proper operation. Use the fol-
lowing procedure to replacing the battery.
Disconnect test leads from any live source, turn the ro-
tary switch to OFF, and remove the test leads from the
input terminals.
The battery cover is secured to the bottom case by a
screw. Using a Phillips-head screwdriver, remove the
screw from the battery cover and remove the battery
cover.
Remove battery and replace with a new equivalent 9-volt
battery.
Replace the battery cover and reinstall the screw.
16
The is displayed when the
battery voltage drops below the
operating level
Approx. 1 hour
2.5 times per second, nominal
0°C to 50°C, < 70% relative humidity
battery removed from meter
Stated accuracy at 23°C ± 5°C,
< 75% relative humidity
0.1 x (specified accuracy) per °C
(0°C to 18°C, 28°C to 50°C)
6561.7 Feet (2000M)
Single standard 9-volt battery,
NEDA 1604, JIS 006P, IEC 6F22
150 hours typical with alkaline battery
214.5mm (H) x 66mm (W) x 44mm (D)
Approx. 258g including battery
One pair test leads, 9V battery
(installed) and Operating Instructions
the battery