Transporting Lithium Batteries; Maintenance; Troubleshooting - Milwaukee M18 BTP Originalbetriebsanleitung

TRANSPORTING LITHIUM BATTERIES

Lithium-ion batteries are subject to the Dangerous Goods Legisla-
tion requirements.
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
The user can transport the batteries by road without further
requirements.
Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation and
transport are exclusively to be carried out by appropriately trained
persons and the process has to be accompanied by corresponding
experts.
When transporting batteries::
Ensure that battery contact terminals are protected and insulated
to prevent short circuit. Ensure that battery pack is secured against
movement within packaging. Do not transport batteries that are
cracked or leak. Check with forwarding company for further advice

MAINTENANCE

Maintain pump and accessories. Check for misalignment or binding
GB
of moving parts, breakage of parts and any other condition
that may affect the pump's operation. If damaged, have the
pump repaired before use. Accidents can be caused by a poorly
maintained pump.
• Remove the battery pack before starting any work on the
appliance. Release all pressure within the system before servicing
any component.
• Drain all liquids from system before servicing.
• Periodically inspect pump and system components, checking for
weak and/or worn hoses. Check impeller for wear or blockage.
Ensure all connections are secure.
• When servicing a pump, use only identical replacement parts.
Follow instructions in the Maintenance section of this manual.
Use of unauthorized parts or failure to follow maintenance
instructions may create a risk of electrical shock or injury and may
void the warranty.
• Do not modify or attempt to repair the pump or the battery pack
except as indicated in the instructions for use and care.
• Cleaning and user maintenance shall not be made by children
without supervision.
Only use the appliance if it is in perfect condition.
Repairs should only be carried out by qualified persons using
original spare parts otherwise this may result in considerable
danger to the user.
Clean tool and guarding system with dry cloth.
Certain cleaning agents and solvents are harmful to plastics and
other insulated parts.
Regular maintenance and cleaning provide for a long service life
and safe handling.
Compliance with the specified service work and service intervals is
mandatory.
Only carry out maintenance work described in the operating
instructions.
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
English
Deutsch
12
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on the
label and order the drawing at your local service agents or directly
at: Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364 Win-
nenden, Germany.

TROUBLESHOOTING

PROBLEM CAUSE
Pump will not run. Impeller blockage.
Flow rate is too Inlet/Outlet line
low. is clogged or
damaged.
Inlet connection is
not airtight.
Impeller cover is
not secured tightly.
Impeller worn out.
Pump shutdown. Dry pump
shutdown.
Locked impeller.
Battery installed
when pump turned
on.
Over temperature Blocked outlet line.
shutdown
Outlet line too
high.
Outlet line too
long.
Pump ON for too
long.
CORRECTION
See „Impeller
Replacement/
Clearing"
Replace Inlet/
Outlet line. Check
lines for blockages,
kinks or bends.
Clear blockages.
Tighten inlet
connection, adding
teflon tape or a
gasket if necessary.
Hand tighten four
(4) cover screws.
See „Impeller
Replacement/
Clearing"
Correct situation,
then turn tool off,
then back on to
reset.
Allow pump to
cool.
Correct situation,
then turn tool off,
then back on to
reset.