Safety Instructions - Kerbl Onyx Montage- Und Bedienungsanweisung

EN
– 1. General instructions: The present operating and safety instructions are for the user.
Please read the instructions carefully and thoroughly and take heed of the regulations before putting
the device into operation!

2. Safety instructions:

• In the event of improper use of and tampering with the device, the warranty and liability of the manu-
facturer will be rendered null and void. The voltage given on the name plate must correspond to the
voltage of the power source.
• Damaged parts are only to be repaired by a specialist or by the manufacturer. Repairs done impro-
perly can result in accidents for the operator. Use only original parts for any eventual repairs.
• Before cleaning, rearranging or servicing the device always first pull the plug from the power source!
• Do not use the connection line to pull the plug from the power source or to carry the device. Take
precautions that the connection lines are not exposed to heat, oil or sharp edges. Damaged con-
nection lines can cause fires, short-circuiting and electric shocks. In the event that the connection
line of this device gets damaged, it must be replaced by a special connection line available from the
manufacturer or from customer service.
• Always store your device securely, out of reach of children, and dry. Heed all possible maintenance
regulations. Check the device at regular intervals. Use only original spare parts and accessories.
• Never submerge the hair trimmer in water, never use a caustic solution. Clean the housing using
only a cloth slightly dampened with water or a mild soap solution.
• National and international safety, health and labor regulations are to be heeded.
How to use the
comb attachment
Blade adjustment ring
contrast list
0.8 = 0.8 mm
• = 1.1 mm
1.4 = 1.4 mm
• = 1.8 mm
2.0 = 2.0 mm
How to mount
and dismount the blade
• Blade taken-down:
Hold the handle of the hair trimmer
firmly and push the upper part of the
blade away from the housing by the arrow.
• Blade assembly:
1. To reassembly scaling at 2.0
2. Pushing the blade block until it
clicks firmly into position by the
arrow
• Pushing the comb attach-
ments down
• To mount the comb attach-
ments, scaling at 0.8
Disposal in EU countries
Do not dispose of the appliance with domestic refuse. As part of the EU
Directive governing the disposal of electric and electronic appliances, the
appliance is accepted free of charge by local waste collection points or recy-
cling centers. Correct disposal will ensure environment protection and pre-
vent a potential harmful impact on people and the environment.
4
• To remove the comb
attachment: push the
attachment off the trim-
mer body in the indicated
by the arrow.
Caution - Before using
the hair trimmer, lubrica-
te the blade with 2-3
drops of oil by the arrow.
Voltage of motor: DC 3V
Rated power: 3.5w
Speed of motor: 6900r/min
Recharge duration: 5 hours