Troubleshooting; Specifications - Pioneer S-W90S Bedienungsanleitung

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances
being used If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized
service center or your dealer to carry out repair work.
SYMPTOM
1 No power is being supplied
(Indicator does not light up when
power switch is turned on.)
2 No sound
(Indicator is lit.)
3 Sound is distorted.
4 Howling noise occurs.
5 Much noise when listening to AM
or FM broadcasts.

SPECIFICATIONS

Cabinet ......................................................... Floor type system
Speaker (Magnetically shielded type) ........... 16 cm cone type
Power Amplifier Continuous Power Output (RMS)
.................................................. 85 W/4 Ω (30 Hz to 200 Hz)
÷
Above specifications are for when power supply is 230 V.
Input (sensitivity at 100 Hz/impedance)
LINE LEVEL (RCA jack) ..................................... 180 mV/50 kΩ
Turnover Frequency ... 50 Hz to 200 Hz (continuously variable)
Outline Dimension
............................ 300 mm (W) x 375 mm (H) x 380 mm (D)
Weight (without package) ............................................ 11.5 kg
Power Requirements ............... 220 V to 230 V~, 50 Hz/60 Hz
Power Consumption ......................................................... 80 W
Accessories ................................................. RCA plug cord x 1
NOTE:
Specifications and design subject to possible modification without
notice, due to improvements.
8
En
En/Fr
CAUSE
÷ Power supply plug is not correctly
inserted.
÷ Connection of speaker or accessory RCA
plug cord is wrong or disconnected.
÷ LEVEL knob is set to MIN.
÷ Level is too high.
÷ Input level is too high.
÷ Power supply to amplifier or speaker
switch is turned off.
÷ Subwoofer level is set too high.
÷ The AM loop antenna or the FM indoor
antenna is close to this unit.
Operating instructions x 1
Warranty card x 1
÷ Insert plug securely.
÷ Check again and connect correctly.
÷ Turn clockwise slowly.
÷ Turn the LEVEL knob counter-clockwise to
lower the level.
÷ Turn the amplifier's output level (volume,
bass control, bass boost) counter-
clockwise to lower the level.
÷ Connect power supply to amplifier and turn
speaker switch on.
÷ Place the subwoofer a good distance from
speakers. Turn the LEVEL knob counter-
clockwise to lower the volume.
÷ Increase the distance between the AM or
FM antenna (for indoor use) and this unit.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power
cord when your hands are wet as this could cause a
short circuit or electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed such that they
are not likely to be stepped on. A damaged power cord
can cause a fire or give you an electrical shock. Check
the power cord once in a while. When you find it
damaged, ask your nearest PIONEER authorized
service center or your dealer for a replacement.
REMEDY
S002_En
Published by Pioneer Corporation.
Copyright © 2007 Pioneer Corporation.
All rights reserved.