Tesla 3 Gebrauchsanleitung Seite 6

CROSSBAR INSTALLATION:
10
Ensure all four hooks are engaged, properly
aligned (step 5-6), and in the upright
position. Then, carefully place the front and
rear crossbars (4-5) over the pads.
Install the wingnut (11) and hand tighten
11
onto each of the towers.
Tighten the wingnuts with the hex wrench
12
vehicle. We recommend tightening to 2.5-
fig. 1
installed, pull in all directions and ensure
there's no movement. In order to lock the
system, the mark on the wingnut must align
*Overtightening may result in vehicle
damage.
06