Emptying The Waste Bin - Lema KSM 1050 Bedienungsanleitung

BUTTON 1 (Light cleaning, indoors, concrete, quartz, smooth
floors, etc.)
BUTTON 2 (Medium cleaning, carpet or other surfaces)
BUTTON 3 (Heavy duty cleaning, outdoors, asphalt or rough
surfaces with rubble, etc.).
NOTE: the parameters of programmes 1, 2 and 3 are factory
set. To modify any of the settings, contact the retailer's service
centre.
Adjust maximum forward movement speed according to the
working conditions
NOTE: the relevant left or right indicator light will come on.
To move the brushes back to their OFF position, pull up the
knobs.
The speed of the side brushes can be changed using the
adjustment knob shown in the figure.
The machine features a red emergency stop button.
Press this button (the red warning light will come on) to bring
all machine functions, engine included, to an immediate stop.
To restart the machine, press the red button down and start up
the functions requested.
If you are using the machine on wet ground, it is essential to
protect the machine's paper filters by turning off the aspirator
motor with the ON/OFF button.
English (Translation of original instructions)
FURTHER PERFORMANCES OF THE MACHINE FEA-
The version featuring an endotermic engine can guarantee
the same working efficiency even when the motor is off, for
instance when the fuel has run out or when working in closed
environments. The working autonomy, in this case, will depend
on the capacity (Amperes/hour) of the batteries installed, on
the intensity of the work programme chosen and on the battery
charge status.
To guarantee the working life of the batteries, the machine
features some safety systems:
1 When the battery voltage drops below 20.5 Volt, all machine
functions, with the exception of the traction system, are
automatically stopped. When this situation occurs, recharge
the batteries or turn on the engine.
2 Protection against excessive battery charging Being fitted
with a current generator featuring an electronic circuit, that
acts as voltage regulator, the machine can correctly charge the
battery without damaging it with an excessive charge.
In fact, when the battery has been properly charged, it will
except no further charging energy.
3 Using the machine with a battery or engine Further to the
tests effected and the results obtained from the evaluation of
the energy consumption of our hybrid system, we can affirm
that Genius 1050 can work autonomously. In other words, the
machine does not have to be stopped to recharge the set of
batteries . Tests have been made with all three programmes
at the user's disposal, namely P1, P2 and P3, on asphalted
surfaces and normal slopes, and the sweeper has worked
autonomously.
However, being the machine designed also for heavy duty
working conditions (slopes of over 16%, extremely rough
surfaces to clean), the batteries may need to be recharged.
In this case, we recommend the use of an intelligent battery
charge with a IUIa charging curve and a final proportional
charge, appropriately designed for this kind of machine and of
a suitable size for the battery installed.
After you have ended your work, disable the selected
programme (1-2-3) and turn off the engine by flicking the
toggle switch 'I' to OFF.
Before leaving the machine, make sure that the side brushes
are raised from the floor, the parking brake is engaged and
that the ignition key has been take out of the instrument board.
- 20 -
TURING AN ENDOTHERMIC ENGINE

EMPTYING THE WASTE BIN