Honeywell Esser SS90 Bedienungs- Und Installationsanleitung Seite 24

24
V1 LED display - red
V3 LED display - yellow
H1 Buzzer
S10 DIL switch setting depending on the panel that is connected
(see also resistor value R4 to R8)
(See Section 4 for coding)
BR8 Solder jumper – micro switch S 1
(Coding, see Section 4)
Default setting
BR9
Solder jumper – power drill protection
Default setting
Optional setting
R4
Resistors not inserted in default setting (in additional bag)
to Assembly and resistor value depends on the panel that is
connected (see also DIL switch setting)
R8
Parallel connection of resistors for resistor adaptation possible
R8
in HB/MB Series IAPs
R8
In default setting second switch contact
S1
(with BR8 coding as opener)
Tamper rupture contact
S2
Tamper lid contact
S3
Sustained or momentary contact for arming/disarming (default is
S4
sustained contact, read assembly and installation instructions)
Flat cable connection
X1/X2
X3 Power drill protection connection – pay attention to BR9!
X4 Rupture contact S2
in cavity wall installation without function
(jumpers in additional bag)
X5 Terminal strip (A, B, 1 to 12)
Strain relief for connection cable
A
System ground housing lid
B
Cable entry
C
1 2 3
Power drill protection not enabled
Power drill protection enabled
Key switch SS90
as NO contact
close X4 bridge