JL Audio JX360/2 Benutzerhandbuch Seite 13

JX360/2
APPENDIX B:
JX360/2 Specifications
Amplifier Section:
Amplifier Topology: Class A/B
Power Supply: Unregulated PWM switching type
Frequency Response: 20 Hz - 20 kHz +0/-1 dB
Signal to Noise Ratio:
>100 dBA referred to highest rated power per ch.,
>77 dBA referred to 1W (20 Hz - 20 kHz Bandwidth)
Damping Factor: >60 @ 4 ohms per ch.
THD + Noise @ Rated Power: 1 %
Rated Continuous (RMS) Power @ 14.4V:
Stereo, all channels driven:
110W RMS x 2 @ 4 ohms
180W RMS x 2 @ 2 ohms
Bridged:
360W RMS x 1 @ 4 ohms
Rated Continuous (RMS) Power @ 12.5V:
Stereo, all channels driven:
90W RMS x 2 @ 4 ohms
140W RMS x 2 @ 2 ohms
Bridged:
280W RMS x 1 @ 4 ohms
Signal Processing:
Filter Type: 12dB/octave High-Pass or Low-Pass with
continuously variable cutoff frequency selection from
50 - 200 Hz. Defeatable.
Preamp Output: 2-Channel, unbuffered pass-through
with RCA-type jacks.
Input Section:
No. of Inputs: One Stereo Pair
Low-Level Inputs: Single-ended with RCA jack inputs
Low-Level Input Range: 200mV - 4V RMS
High-Level Inputs: Single-ended with molded connector
High-Level Input Range: 2V - 10V RMS
.
Power Connections:
Recommended Fuse Value (Type): 50A (MAXI or AGU)
Minimum Copper Power/Ground Wire Gauge: 4 AWG
Dimensions (LxWxH):
12.80" x 7.68" x 2.15" (325 mm x 199 mm x 55 mm)
Net Weight:
7.6 lbs. (3.45 kg)
Due to ongoing product development, all specifications are subject to
change without notice.
13