Nortel Networks Business Policy Switch 2000 Installationsanweisungen Seite 24

24
6 For a standalone switch, in the In-Band Switch IP Address field, enter the IP address of the
switch in dotted-decimal notation.
Note: If the In-Band Subnet Mask field does not already contain a value when you enter
the IP address in the In-Band IP Address field, the switch software provides an in-use
default value for the In-Band Subnet Mask field. This value is based on the class of the
entered IP address.
7
For a stack configuration, in the In-Band Stack IP Address field, enter the Stack IP address in
dotted decimal notation.
Note: The In-Band Switch IP Address field allows this switch to operate as a standalone
switch. However, this field is not required for the operation of the stack. You cannot enter
the same IP address in both fields.
8 In the In-Band Subnet Mask field, enter the IP subnet mask address.
9
In the Default Gateway field, enter the default gateway address.
209319-A