Canon Mixed Mode - Rollei Profi Funk-Sender 2,4 GHz Gebrauchsanweisung

Canon mixed mode

46
1. Group mode and parameter setting
1) Press the mode button to select the
transmitter mode universal mixed mode
(as shown on the picture) .
2) Press A, B, C, D shortly to select or exit the
flash group setting . The arrow on the LCD
screen indicates in which group settings
your are .
3) After you have selected the group press the mode button to set the flash
mode for this group . The mode parameters are as follows:
TTL: The exposure compensation can be set from -3,0EV to +3,0EV . In total
you have 22 levels . Press the left and right button to change the exposure
compensation . Press the up and down button to adjust the zoom settings
(focal distance) .
M: In the manual mode the flash output can be set from 1/128 to 1/1 . With
the left and right buttons the values can be increased or decreased by 0,3 EV
(in total 22 levels) . Press the up and down button to adjust the zoom settings
(focal distance) .
OFF: If the group is turned off, it will not flash .
4) After the group parameters are finished, press again the corresponding group
button (A, B, C, D) to exit the settings and set the flash units all to the same
channel as the trigger . The group power can be adjusted individually for each
group . But if the flashes of all three groups should fire at the same time, they
need to be in the same channel .
ENGLISH