Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Advice - LAGUNA BADWELTEN Platino 2.0 Montageanleitung

Vorschau ausblenden Andere Handbücher für Platino 2.0:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3

sAFeTY ADVIce

• The mounting must only be done by experts.
• Warning: defective mounting is dangerous!
• check whether the wall is suitable for the mounting and
that the fasteners are strong enough for the forces involved.
• Please read through the mounting instructions carefully
before mounting in the bathroom.
• The enclosed fastening material is only suitable for solid
walls of sufficient load-bearing strength.
electrical installations should only be carried out by a
specialist electrician DIN VDe 0100-701 (VDe 0100-701):2008-
10.
• electrified, mirrored cabinets and flat mirrors must be loc-
ated at a minimum distance of 600 mm away from the bath
or shower.
• The safety regulations and standards of the particular coun-
tries must be observed.
IMPOrTANT INFOrMATION
• Inspect the packaging for external damage when it is delivered.
• Please check the number of bathroom cabinets supplied and
the associated sets of ironmongery (screws, cover caps,
handles, etc.) against the delivery note or the article's label
on the packaging.
• Caution: only remove the protective caps on the mirrored
cabinet's doors after mounting the doors, in order to avoid
damaging edges of the mirrors.
• Use suitable spacers or distance blocks to even out the
existing differences in level caused by coverings applied to
the walls, e.g., partial tiling.
• reinforce any walls of insufficient load-bearing strength.
• The drilled dimensions are measured from the FFL according
to the dimensioned layout.
• Fasten the cabinets with the suspension rails:
- Washstand vanity unit
- shelves (no lighting)
- Highboard
- tall cabinets (600 mm width)
• Always fasten the hanging bar to the wall with 2 screws!
• Do not tighten water tap and sink pop-up too firmly.
TOOLS
• Drill and battery-operated screwdriver
• stone drill bit of 8 mm dia, 10 mm, 12 mm, 14 mm
• Wood drill bit of 4 mm dia
• Folding metre rule and measuring tape
• Spirit level
• screwdriver with a 3.5 mm tip for Phillips screws
• 10, 13, 17 wide open-jawed spanner
• 4 mm Allen key
• screw clamps
• Pencil
• silicone sealant (transparent and solvent-free)
Laguna Platino 2.0
MAINTENANCE INSTRUCTIONS
• Caution: do not use any chemicals, aggressive detergent
paste or scouring powder.
• The best way of cleaning the cabinet is to use a damp cloth
with some mild washing-up liquid.
• Take care that no residue from droplets remains on the lower
edge of bathroom cabinets.
• Polish the mirror with a damp cloth or chamois leather.
• The washbasin can be easily cleaned with any of the usual,
non-abrasive cleaning agents.
• Ventilate regularly in order to prevent the mould from forming.
keeP THe INsTrucTIONs IN A sAFe PLAce
i
Caution: keep the instructions safely because they contain
information about installing and operating the products.
MOUNTING SEQUENCE
i
For the figures, see the attachment
1. Remove the doors and drawers (Figs. A/A1)
2. Mount the lamps (Fig. B/B1)
The mains wire should not be live!
3. Hang up the furniture
· Mirrored cabinet or flat mirror
(centre of the mirrored cabinet = centre of the water
supply connection)
· upper cabinet, shelves, Protoboard
· Washstand vanity unit
· Base cabinet
· centre cabinets
4. Mount the plate/cabinet
(middle washstand section = middle water connection)
· Apply panel and align (Fig. C)
· seal the plate (Fig. D)
· Mount the washstand vanity unit cabinet/shelf (Fig. D/D1)
5. Mount washstand
For the installed vanity unit:
· Putting on the washstand (Fig. E)
· Fasten vanity unit and seal (Fig. E1)
For top vanity unit:
· Attach vanity unit and fasten (Fig. E2)
· sealing the washstand (Fig. E3)
6. Align furniture (Fig. F/F1/F2)
7. Install the tap (Fig. G)
· Warning: Use the enclosed rubber seal.
· Do not overtighten the tap!
8. Screw on the shelf (Fig. H)
· Warning: Do not drill through the shelf!
· use the enclosed screws.
9. Mount the protoboard (Fig. I)
10. Mount the doors and drawers (Fig. J/J1)
11. Align the doors and drawers (Fig. K/K1/K2/K3)
12. Mount the rollers (Fig. L)
13. Adjusting the folding hinge (Fig. M)
Laguna Platino 2.0
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis