Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manual Setup
If ISP is not on the list or if Automatic setup doesn't work, please
use the Manual Setup.
Please obtain the Encapsulation, VPI, VCI information from your ISP.
Different Encapsulation type will bring up different setup screen.
If your ISP use PPPoE for connection and you want the AM-100E to
function as a modem only. Please change the Encapsulation as
followed:
•
PPPoE LLC -> 1483 Bridge LLC
•
PPPoE VcMUX -> 1483 Bridge VcMUX
(If you are unsure whether it's LLC or VcMUX, please use LLC)
Then follow the 1483 Bridge instruction in method B. The PPPoE
authentication should be done by broadband routers (connected
below the AM-100E).
A.
For ISP with the following "Encapsulation".
PPPoA-LLC
PPPoA VC-Mux2
1.
Please enter the Encapsulation, VPI, VCI information from your ISP
and press "Next"
2.
Enter your "Service Name"(not required for some ISP), "User
Name" and "Password" from Service Provider (ISP).
3.
Click "SAVE" after setup. Please wait for 30 seconds for the
modem to reboot.
4.
Go to the "Setting Half Bridge" section.
5.
After finish all AM-100E settings, please refer "Restore TCP/IP
Configuration" to restore your PC's IP settings
Wired Ethernet ADSL Modem
AM-100E
English
7
7
Werbung
Inhaltsverzeichnis
