Power Craft 89040 Gebrauchsanweisung Seite 38

Correct spray technique
1. To achieve best result hold spray gun
23-30 cm from surface to be sprayed.
This prevents air getting into the pump
until the liquid runs out.
2. Uneven spray movements will cause
bubbles and runs in the paint. Always
use smooth, even arm movements.
3. Use arm, not wrist (6-7).
GB
Figure 6
Figure 7
Some tips
• Always clean the surface fi rst for the
best result. Clean and protect surface
from dust.
38
• Check for correct setting by trying out
on a price of board or the like.
• Use good quality paint. This will help
avoid runs. If applying more than one
coat, allow each coat to dry properly
before applying the next.
• Cover all other surfaces to avoid
accidental spraying.
• See illustration number (8) for the best
method.
Figure 8
• Remember that excess paint can fall on
the surrounding areas.
Cleaning
1. Always fi ll with a little thinners after
painting is fi nished to clean internal
parts. Remember not to exceed the
fl ashpoint of 21º C.
2. Disconnect from the mains.