Cleaning And Maintenance; Safety Advice; Cleaning - Bartscher 610.182 Bedienungsanleitung

6. Cleaning and maintenance

6.1 Safety advice

o Before beginning with repair or cleaning works make sure the device has been
disconnected from power socket (pull the power plug!!!) and has cooled down.
o Do not use any acid agents and make sure no water ingresses the device.
o To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!

6.2 Cleaning

o The device should be cleaned regularly.
o Clean the device with a damp cloth after each use. Thoroughly remove any food or
beverage splashes on the interior walls with a damp cloth. You may also use a mild
detergent in case of heavier dirt accumulation.
o Avoid using sprays and other aggressive cleaning agents as these may leave
residues or even damage the surface.
o Clean the outer surface with a damp cloth. Water may not penetrate the ventilation
slots to protect sensitive inner parts from damage.
o Wipe the door, the sealing and connected parts with a damp cloth to remove all dirt.
Do not use any aggressive cleaning agents.
o The control panel must not become wet. You may wipe it by using a soft, damp
cloth. Make sure the door is open while cleaning the control panel in order to avoid
accidental engaging of the device.
o You may wipe away condensed water that has formed at both sides of the door,
using a soft cloth. This may occur when the device is operated in areas with high air
humidity. Formation of condensed water is absolutely normal.
o In order to dispose bad smells from the cooking chamber you may place a cup of
water together with the juice and the paring of a lemon in a microwave-proof
container and heat it for approx. 5 minutes. Afterwards you may wipe over using a
dry, soft cloth .
o Only use a soft cloth and make sure you never use any kind of abrasive agents or
pads which could scratch the surface.
o After the cleaning procedure, you should use a soft and dry cloth to wipe dry and
polish the surface.
o Make sure the device has been cleaned properly before storing it in a dry place.
- 39 -