Installation And Use; Safety Instructions; Use - Casselin CMS2B Handbuch

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Risk from electrical current!
• No contact with heat sources must take place with the power cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water in the unit in operation or still hot.
• The device must be connected properly and comply with regulations.
WARNING
By operating the apparatus may reach high temperatures. To avoid burns and accidents, do not use the
machine malfunction and do not use spare parts that do not origins.
ELECTRICAL HAZARD
Risk from electrical current!
In case of improper installation, the device can be dangerous and cause injury. Before installation, check the
power system data. Connect the device only when there is compliance. The unit should be unpacked and
checked fully before connecting by a professional.

5.2 Use

WARNING
The establishment of the installation of the device and maintenance must be performed only by professionals.
• Do not leave the unit without monitor.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
INSTALLATION
The unit must be completely removed from its packaging. All guards must be completely removed.
Place the machine upright on a solid, flat surface Do not put the device on a flammable surface.
Do not install this device near open fires or other heating appliances.
It is prohibited to place on the device or in the distance less than 10 cm of the device flammable objects.
Place the unit in a hood to eliminate steam and odors.
The safety distances for flammable materials according to their degree of flammability:
A nonflammable granite, sandstone, concrete, brick, ceramic tile, coated
B flammability acumin, jefferson, lihnos, itaver
C1 poorly flammable wood Hardwoods trees, against-plated, hardened paper umakart
C2 average flammability chipboard solodur, cork, rubber, coatings
C3 easy flammability of wood fiber boards, polystyrene, plyurethène, PVC
The electric cable must be protected at least 16 amperes. The device must be plugged directly into a wall
outlet. Using a power strip will crack up the device.
When the apparatus is placed against a wall, it must be able to withstand a temperature of 60 ° C.
If this is not the case it is necessary to insert a protective layer.
Ensure that all openings for ventilation are not obstructed.
Thoroughly clean all parts of the device before use with a suitable product. The control box should not be in
water or contact with moisture.
The device can be used in an ordinary space to EN 332000-1
MANUAL
Before first use the device should be cleaned with a damp cloth and a suitable detergent. Rinse and dry.
Fill the outer 0.6 liter water tray and then fill the inner container with the desired food.
EN