Installation - K.e.r.t Cosmo 1500 Handbuch

PRECAUTIONS TO TAKE TO ASSURE GOOD OPERATION OF YOUR INSTRUMENT
1. Do not put the instrument close to heat sources.
2. The ambient temperature must not exceed 40° C with a maximum humidity of 80%.
3. Keep the instrument far away from magnetic sources.
4. Do not put excessive weights on top of the cabinet.
5. Do not obstruct the air intakes.
6. It is best to discharge the condensers before feeding the circuits.
7. As is true with all digital instruments, it is best to have the instrument calibrated once a year. This operation can be
performed by a qualified technician, by an authorised assistance centre or directly at the K.E.R.T. factory.
8. Do not clean the instrument with abrasives or solvent. Use a moist rag with detergent.
a. Selecting the location
The COSMO - SYSTEM series of power supplies are provided with forced cooling so they do not have any functioning pro-
blems, even in environments having high temperatures.
Notwithstanding this feature, the air intakes MUST be left unobstructed for the forced air inlet and outlet that are situa-
ted on the sides of the cabinet near the bottom panel. The device is however equipped with a thermal circuit breaker that
disconnects the power supply in the event of overtemperature.
b. Assembly
The device is supplied pre-mounted and complete with all its parts.
c. Electrical connections
The mains power supply cable is the EURO STANDARD type and the outlet is situated on the rear panel.

INSTALLATION

pag. 9
GB