Opvimus PM-712/0 Gebrauchsanweisung Seite 14

E N G L I S H
Figure 5
ENG
ENG
ESP
In this way, an output card can be placed at the end of each section (in the position right before the position where
the jumpers have been disconnected) so that a PM-712/0 with 12 card positions can be transformed into a
PM-712/0 with several groups of cards, each group being independent from the rest, and with cascade priority
inside each group (see example in figure 7).
To install any card in the bus, you must remove the jumper between contacts 8 and 9 in the bus connector
(see figure 6).
Card position
Priority ranking
The bus jumpers between card positions 4 and 5 (J34, J35, J36 and J37) and between card positions 8 and 9
(J18, J19, J20 and J21) are removed.
Two more output cards (card positions 4 and 8) are installed.
Card position
Priority ranking
Thus, a PM-612 with 12 cards can be turned into three independant PM-612.
16
PM-712/0
Figure 7
OUT 12 11 10 9 8 7
OUT< 12 < 11 < 10 < 9 < 8 < 7 < 6 < 5 < 4 < 3 < 2 < 1 < IN
OUT 12 11 10 9 8 7
OUT< 4 < 3 < 2 < 1 OUT < 3 < 2 < 1
6 5 4 3 2 1 IN
6 5 4 3 2 1 IN
OUT <3 < 2 < 1 < IN
Figure 6
PM-712/0