Iget GA80 Pro Benutzerhandbuch Seite 30

EN
Installing the NANO SIM and microSD card:
Switch your phone off before installing the cards.
1. Pull the pin for ejecting the SIM card slot from
the package.and insert it into the hole in the
compartment for the SIM card until until it jumps off
from the body of the phone.
2. Gently remove the compartment out of the slot.
3. a) 2x NANO SIM or b) 1x NANO SIM and 1x
micro SD card align as shown in the manual and
gently insert them into the compartment.
4. Put the entire compartment together with the
cards back into the phone. Ensure the correct
orientation – cards to the back of the phone!
Charging the battery:
Before putting your phone into service you must
recharge its battery.
1. Connect the adapter to the charger. USB-C can
be rotated from both sides. Yet when attaching the
connector, do not use violence.
2. Connect the charger to the wall outlet.
3. If the battery is fully charged, disconnect the
phone from the charger.
Switching the phone on/ off/ sleep mode:
Make sure that the phone has a SIM card and the
battery is fully charged.
Press the ON button to switch on the phone.
Switch off the phone by pressing ON and select
OFF. Confirm it by pressing OK.
Press shortly ON button to switch the phone over to
the sleep mode.
30