Operating; Switching On; Forward Operation; Reverse Operation - Westfalia 86 02 74 Originalanleitung

Switching ON

Before inserting the power cable to mains, make sure the appliance is
switched off by pressing the OFF switch once.

Forward Operation

1. Press the ON switch I/II once. By pressing the button again the
motor unit will run with higher speed.
2. To switch off the appliance, press the OFF switch.

Reverse Operation

Press the REV switch for reverse operation. Use this function if the
cutter housing is blocked or clocked.
Attention: Wait until the motor has come to standstill before pressing
the reversal button.
If the blocking cannot be released at all, switch off the appliance. Pull
the power plug, disassemble the cutter housing and clean it thoroughly.
Hints
 Allow the appliance to make 4 – 5 turns without food, so remaining
food can fall into the bowl.

Switch off the appliance and pull the power plug.

Please note, the grinding disc might get stuck onto the worm shaft
and cannot be removed easily. To remove the grinding disc, use a
suitable and clean object and lift up the grinding disc from the
worm shaft.

Accessories

The coarse grinding disc (12) is intended to be used for making ground
meat and the fine and medium grinding discs (9) and (10) are intended
for making fine minced consistency for sausages.

Operating

18