Getting Started - Samson Meteor M2 Bedienungsanleitung

Getting Started

The Meteor M2 input connections are made via the rear panel of the powered speaker. Follow the simple steps and diagram below to setup
your speakers.
1. Connect the left speaker hard wired cable to the right speaker. Plug the wire into the RCA speaker output on the back of the right
(active) speaker.
2. Using the supplied audio cable, connect the audio output from your audio source such as a computer, MP3 player or portable audio
device to the 1/8" input of the Meteor M2 right side speaker.
3. Connect the Meteor M2 to an AC power outlet using the included power adapter.
4. Turn the speakers on by pressing the Meteor M2 power switch for >1 second. The front panel indicator will light blue.
5. Turn the Meteor M2 volume control completely down by pressing and holding the "–" button on the side of the right speaker. The front
panel indicator will flash for each volume step up or down. When the speaker reaches the minimum or maximum volume setting the
indicator will stay lit.
6. Set the audio
output from your
audio device to the
maximum setting.
Play music from
your audio source
and slowly raise the
volume of the Meteor
M2 to a comfortable
listening level.
8