Chapter 3: English; Cable Requirements; Mounting The Wlan Ap 8120 With External Antenna On A Wall - Avaya WLAN AP 8120 Vorschriften

Chapter 3: English

Using the following procedures and information when installing the Avaya WLAN AP 8120 with External
Antenna access points.

Cable requirements

The Ethernet ports on the access point cannot accept a CAT-5 cable that has an uneven sheath
as shown below. The RJ-45 connector on the cable will not seat properly in the receptacle on
the access point. Use a CAT-5 cable with an even sheath instead.
Mounting the WLAN AP 8120 with External Antenna on a
wall
The WLAN AP 8120 with External Antenna installs similarly to the WLAN AP 8120. In addition
to installing the access point itself, with the WLAN AP 8120 with External Antenna you must
also mount the adjoining antennas. You can mount the WLAN AP 8120 with External Antenna
on the wall using wall anchors.
Plan your installation to allow for the installation of both the access point and the antennas.
Ensure you have the correct length of cable to connect the access point to the antennas. Each
antenna comes with three 3–ft pre-installed permanent cables. If your installation distance is
greater than the length of the original cables, you can attach additional 10–ft extension
cables.
Avaya WLAN 8100 Regulatory Information - WLAN AP 8120 with External Antenna October 2011 17