Chapter 3: English; Introduction - Avaya WLAN 8100 series Handbuch

Chapter 3: English

About this task
Using the following procedures and information when installing the Avaya WLAN AP 8120-O.

Introduction

This section describes site conditions required before installing the WLAN AP 8120-O access
point.
Site Planning
Perform a visual inspection to determine and document the physical characteristics of the site.
Ensure that the site planning meets the following requirements before you begin the
installation:
• Identify the roof area, wall, or tower for mounting the WLAN AP 8120-O.
• Choose a site with a clear line-of-sight from the transmitting antenna.
• Determine the access area, such as a stairway or a ladder.
• Identify existing equipment installations and assess the condition of proposed towers or
mounting structures.
• Assess environmental conditions, such as temperature, ventilation, and humidity.
Ethernet
The WLAN AP 8120-O must be closer than 100 meters from the Power over Ethernet (PoE).
Note:
Avaya recommends that you use outdoor CAT5E Ethernet cable for all external
connections.
Antenna
The WLAN AP 8120-O uses two 5.0 GHz and two 2.4 GHz antennas.
Caution:
Only use Avaya approved antennas with the WLAN AP 8120-O. A WLAN AP 8120-O that
is outfitted with non-certified Avaya antennas is not supported under Avaya support
agreements.
Avaya WLAN 8100 Regulatory Information — WLAN AP 8120-O February 2012 19