Electrolux ERC33430W Benutzerinformation Seite 16

16 electrolux
– avoid open flames and sources of igni-
tion
– thoroughly ventilate the room in which
the appliance is situated
• It is dangerous to alter the specifications
or modify this product in any way. Any
damage to the cord may cause a short-
circuit, fire and/or electric shock.
Warning! Any electrical component
(power cord, plug, compressor) must
be replaced by a certified service agent
or qualified service personnel to avoid
hazard.
1. Power cord must not be lengthened.
2. Make sure that the power plug is not
squashed or damaged by the back
of the appliance. A squashed or
damaged power plug may overheat
and cause a fire.
3. Make sure that you can come to the
mains plug of the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do
not insert the power plug. There is a
risk of electric shock or fire.
6. You must not operate the appliance
without the lamp cover
lighting.
• This appliance is heavy. Care should be
taken when moving it.
• Do not remove nor touch items from the
freezer compartment if your hands are
damp/wet, as this could cause skin abra-
sions or frost/freezer burns.
• Avoid prolonged exposure of the appli-
ance to direct sunlight.
• Bulb lamps 5)
used in this appliance are
special purpose lamps selected for
household appliances use only. They are
not suitable for household room illumina-
tion.
Daily use
• Do not put hot pot on the plastic parts in
the appliance.
• Do not store flammable gas and liquid in
the appliance, because they may ex-
plode.
4) If the lamp cover is foreseen.
5) If the lamp is foreseen.
6) If a water connection is foreseen.
• Appliance's manufacturers storage rec-
Care and cleaning
• Before maintenance, switch off the appli-
• Do not clean the appliance with metal
• Regularly examine the drain in the refrig-
Installation
Important! For electrical connection
carefully follow the instructions given in
specific paragraphs.
• Unpack the appliance and check if there
• It is advisable to wait at least four hours
4)
of interior
• Adequate air circulation should be
• Wherever possible the back of the prod-
• The appliance must not be located close
• Make sure that the mains plug is accessi-
• Connect to potable water supply only.
Service
• Any electrical work required to do the
ommendations should be strictly adhered
to. Refer to relevant instructions.
ance and disconnect the mains plug from
the mains socket.
objects.
erator for defrosted water. If necessary,
clean the drain. If the drain is blocked,
water will collect in the bottom of the ap-
pliance.
are damages on it. Do not connect the
appliance if it is damaged. Report possi-
ble damages immediately to the place
you bought it. In that case retain packing.
before connecting the appliance to allow
the oil to flow back in the compressor.
around the appliance, lacking this leads
to overheating. To achieve sufficient ven-
tilation follow the instructions relevant to
installation.
uct should be against a wall to avoid
touching or catching warm parts (com-
pressor, condenser) to prevent possible
burn.
to radiators or cookers.
ble after the installation of the appliance.
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
6)