Turning On The Projector - Christie LHD700 Kurzanleitung

Turning On the Projector

1 Complete peripheral connections (with a
computer, VCR, etc.) before turning on the
projector.
Connect the projector's AC power cord
2
into an AC outlet. The LAMP/SHUTTER
indicator lights red and the POWER
indicator lights green.
3 Press the ON/STAND-BY button on the
side control or the ON button on the remote
control. The LAMP/SHUTTER indicator
dims and the cooling fans start to operate.
The preparation display appears on the
screen and the countdown starts.
4
After the countdown, the input source that
was selected the last time and the lamp
control status icon appear on the screen.
If the projector is locked with a PIN code, PIN
code input dialog box will appear.
Enter a PIN code
Use the Point ▲▼ buttons to enter a number. Press the Point ► button to fix the number and move
the red frame pointer to the next box. The number changes to . If you fixed an incorrect number, use
the Point ◄ button to move the pointer to the number you want to correct, and then enter the correct
number.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to Set. Press the SELECT button so that you
can start to operate the projector.
If you entered an incorrect PIN code, PIN code and the number () will turn red for a moment.
Enter the correct PIN code all over again.
020-000424-01 Rev.1 (11-2011)
Note:
• When the Logo select function is set to Off,
the logo will not be shown on the screen.
• If the PIN code number is not entered within
three minutes after the PIN code dialog box
appeared, the projector will be turned off
automatically.
• The "1234" is set as the initial PIN code at
the factory.
What is PIN code?
PIN (Personal Identification Number) code is a
security code that allows the person who knows
it to operate the projector. Setting a PIN code
prevents unauthorized use of the projector.
15