Operation; Switching On The Display Unit; Switching On The Mobile Warning Unit - Linde Safety Guard Originalbetriebsanleitung

4

Operation

Operation
Operation

Switching on the display unit

 Switch on the industrial truck.
The display unit starts as follows and runs a
self-test:
The numerical display lights up
●
Depending on the number of sensors, the
●
numerical display counts down from 3 or 4
to 0. The warning zone lights up each time
The switching output LED lights up red and
●
the power supply LED flashes green
The LEDs for the sensors light up red and
●
the switching output LED lights up green
The LEDs for the sensors light up green for
●
ten seconds and then go out. A signal tone
is emitted
After approximately 15 seconds, the display
unit is ready for operation.
Switching on the mobile warning
unit
 Push the push button (1) and hold it until
the mobile warning unit starts.
The mobile warning unit starts as follows:
The mobile warning unit emits a signal tone,
●
the LEDs in the warning zone light up and
the device vibrates.
The starting procedure is completed.
NOTE
If the push button (1) is released too early, the
starting procedure must be repeated. This but-
ton safety device prevents the unit being
switched on and off accidentally in normal op-
eration.
 To switch off the unit, push the push button
(1) and hold it until the mobile warning unit
shuts down.
The LEDs light up briefly. A signal tone
sounds. The mobile warning unit vibrates
briefly and shuts down.
50


1
Operating Instructions - 3008011701 EN - 11/2019
1 2 3 4
LSG_0015
LSG_0016