Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When working, never place a hand
or fingers in front of the saw blade.
The improper use of accesso-
ries which are not intended for
this machine type increases the
danger of an accident and can
lead to damage to the machine.
Connect machines that are used in the open
via a residual current circuit breaker with a trig-
gering current of 30 mA maximum. Use only
extension cables that are intended for outdoor
use and are protected against splash water.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Always direct the cable to the rear away from
the machine.
Apply the machine to the workpiece only when
switched on.
The cutting path must be free of obstacles both
above and blow.
When sawing, the complete surface of the
base plate 12 should securely rest on the ma-
terial. For the working of smaller or thin work-
pieces, use a stable foundation or a saw table
(accessory).
When the cut is completed, switch off the ma-
chine and then pull the saw blade out of the cut
only after it has come to a standstill (danger of
kick-back).
After switching off, do not brake the saw blade
to a stop by applying side pressure.
Use only sharp, flawless saw blades. Replace
immediately cracked, bent or dull saw blades.
Bosch can assure flawless functioning of
the machine only when original accesso-
ries are used.
Intended Use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ceramic
plates and rubber while resting firmly on the work-
piece.
It is suitable for straight and curved cuts with mi-
tre angles to 45°.
The saw blade recommendations are to be ob-
served.
Inserting/Replacing the Saw
Blade
Before any work on the machine itself,
pull the plug from the socket!
The machine is equipped with a
SDS
Bosch SDS (Special Direct Sys-
tem)
makes possible easy and quick
changing of the saw blade with-
out additional tools.
Insert the saw blade (teeth in cutting direction)
until it latches in the stroke rod. When inserting
the saw blade, take care that the back of the saw
blade rests in the groove of the guide roller 8.
To change the saw blade, push the SDS lever 9
to the front to the stop; this releases the saw
blade and it is ejected (see Fig. B).
When changing the saw blade, the ma-
chine should be held so that no per-
sons or animals can be injured by the
ejection of the saw blade.
Initial Operation
The power supply voltage must match the infor-
mation quoted on the tool identification plate.
Switching On/Off
Brief activation
Switching on: Press ON-OFF switch 2.
Switching off: Release ON-OFF switch 2.
Continuous use
Switching on: Press ON-OFF switch 2 and
retain with locking button 3.
Switching off: Press and release ON-OFF
switch 2.
clamping
device.
Note: If the saw blade
cannot be inserted into
the stroke rod because
the slots of the saw
blade holder are not in
the position as shown,
push the SDS lever
briefly to the front and
release.
This
13
Werbung
Inhaltsverzeichnis
