Electrical Safety - Black & Decker KR750 Übersetzung Der Originalanleitung

When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the
times when the tool is switched off and when it is
running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool
along with the date code:
Warning! To reduce the risk of injury, the
user must read the instruction manual.

Electrical safety

Your charger is double insulated; therefore
no earth wire is required. Always check
that the mains voltage corresponds to the
voltage on the rating plate. Never attempt
to replace the charger unit with a regular
mains plug.
♦ If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to
avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Variable speed switch
2. Lock-on button
3. Forward/reverse button
4. Drilling mode selector
5. Chuck
6. Depth stop
7. Side handle
Fig. B
8. Manual spindle lock button (single sleeve key-
less chuck only)
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting the side handle and depth stop
(fi g. A & E)
♦ Turn the grip counter clockwise until you can
slide the side handle (7) onto the front of the
tool as shown.
♦ Rotate the side handle into the desired position.
♦ Insert the depth stop (6) into the mounting
hole as shown.
♦ Set the drilling depth as described below.
♦ Tighten the side handle by turning the grip
clockwise.
Fitting a drill bit
Single sleeve keyless chuck (fi g. B)
♦ Open the chuck by pressing the manual spin-
dle lock button (8) and turning the sleeve (9)
counter clockwise.
♦ Insert the bit shaft (12) into the chuck.
♦ Firmly tighten the chuck by pressing the
manual spindle lock button (8) and turning the
sleeve clockwise until it is tight.
Removing and refi tting the chuck (fi g. C)
♦ Open the chuck as far as possible.
♦ Remove the chuck retaining screw, located
in the chuck, by turning it clockwise using
a screwdriver.
♦ Tighten an Allen key into the chuck and strike
it with a hammer as shown.
♦ Remove the Allen key.
♦ Remove the chuck by turning it counter clock-
wise.
♦ To refi t the chuck, screw it onto the spindle
and secure it with the chuck retaining screw.
Use
Warning! Let the tool work at its own pace. Do
not overload.
Warning! Before drilling into walls, fl oors or
ceilings, check for the location of wiring and pipes.
Selecting the direction of rotation (fi g. D)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or
removing a jammed drill bit, use reverse (counter
clockwise) rotation.
♦ To select forward rotation, push the forward/
reverse button (3) to the left position.
♦ To select reverse rotation, push the forward/
reverse button to the right.
Warning! Never change the direction of rotation
while the motor is running.
Selecting the drilling mode
♦ For drilling in masonry, set the drilling mode
selector (4) to the
♦ For drilling in other materials and for screw-
driving, set the drilling mode selector to the
position.
ENGLISH
position.
33