ACT LABS GS Gun System Benutzerhandbuch Seite 5

Gun Units: Gun Units:
Gun Units: Gun Units: Gun Units:
The GS Gun Units have two buttons. Button one is the trigger
while button two is on the side of the Gun Unit and accessible
with the thumb. Button two is duplicated on both sides of the
Gun Unit so that it easily accessible to right or left handed
shooters. The cable from the Gun Unit plugs into one of the
two circular 13 pin connectors on the back of the Base Unit.
Button 1
Handheld Unit: Handheld Unit:
Handheld Unit: Handheld Unit: Handheld Unit:
The GS Handheld Unit consists of an analog thumb-operated
control stick and three buttons. Buttons one and two are on the
front of the Handheld Unit; pressing down on the control stick
operates button three. The cable from the Handheld Unit plugs
into one of the two circular 13-pin connectors on the back of
the base unit.
Button 1
VGA Pass-Through box: VGA Pass-Through box:
VGA Pass-Through box: VGA Pass-Through box: VGA Pass-Through box:
Button 2
In addition to the VGA connectors for input and output of the
video signal, there is a small thumbwheel control on the side of
the housing labeled "Flash Intensity". Its purpose is to allow
adjustment of the brightness of the flash used for reading the
screen. Depending on the monitor used and the ambient light
levels, it may need to be adjusted from the default (middle)
setting. In general, it is best to adjust the intensity to the lowest
setting consistent with good performance.
5 5 5 5 5
Button 3
Button 2