Fitting Batteries; Touchscreen; External Dvd Drive - Bosch DCU 130 Betriebsanleitung

en 24 | DCU 130 | Commissioning
3.5.3 Status display (LED)
System display LED
Status Function / significance
Not lit DCU 130 switched off
Green light DCU 130 switched on
Flashing green DCU 130 in standby mode, press On/Off key
again to re-activate
Yellow light Read or write hard disk access
Battery LED
Status Function / significance
Not lit DCU 130 switched off
Green light Internal power supply
(battery operation)
Yellow light External power supply
Flashing yellow Battery being charged from
external power supply
Red light DCU 130 operating on residual
battery capacity
WLAN LED
Status Function / significance
Not lit WLAN switched off
Green light WLAN switched on
Flashing green DCU 130 connected to a WLAN network
and data communication in progress
Bluetooth LED
Status Function / significance
Not lit Bluetooth module deactivated
Blue light Bluetooth module activated
Flashing blue DCU 130 connected to a Bluetooth user
and data communication in progress
3.6 Touch screen
The touch screen can be operated by hand or using
a pen for example. To implement an action, touch the
appropriate point on the touch screen with a finger
or pen.
i
Touch screen calibration is described in Section 6.2.
3.7

External DVD drive

Use of the DVD drive is described in section 5.11.
|
1 689 989 091 2014-05-14
4. Commissioning
4.1

Fitting batteries

¶
Insert the two batteries and press home until heard
to engage.
i
It is advisable to charge the batteries for at least
three hours before running the DCU 130 off the
batteries.
4.2 Connection
Prior to commissioning, make sure the mains voltage
coincides with the voltage specified on the power sup-
ply unit (use the power cord provided).
i
The scope of delivery only includes the German
power cord.
4.3 Operating system installation
1. Connect the power supply unit.
2. Switch on the DCU 130.
3. After switching on for the first time, use the langua-
ge selection menu to select the Windows operating
system language and follow the instructions on the
screen.
i
There is no provision for subsequent alteration of
the language. Should this nevertheless be necessary,
please contact your franchized Bosch dealer.
i
Wireless radio link information is displayed during
installation. Please heed these notes. Further infor-
mation can be found in Section 2.5.
4.4 Software installation
The Bosch application software appropriate to the
intended use must then be installed. The corresponding
installation information can be found in the instructions
for each Bosch product.
Robert Bosch GmbH