Aeromax WB-121 Wichtige Sicherheitshinweise Seite 8

800-W LOW-PRESSURE PAINT SPRAYER
Important: See Fig. 12 for an illustration of how to use the device correctly. Always keep a distance
of approximately 5 cm to 15 cm between the spray gun and the object or surface being sprayed.
Move the spray gun from left to right or from top to bottom (Fig. 13).
Regular, controlled movements will spread the paint uniformly. If liquid accumulates in the air tube
and/or spray tube (Fig. 14), clean the tube with water or solvent. Open the spray gun and pour out
any remaining liquid. Clean out the reservoir and tubes with a brush. Fill the reservoir with water
or solvent, screw it back on firmly and spray the solution through the spray gun until the reservoir
is empty.
Note: After each use, spray a small amount of paint thinner through the system to remove any
residue inside the spray tube.
Cleaning
Clean the spray gun immediately after use. Remove and empty the reservoir and rinse with a
solvent recommended for the paint or liquid used. Fill the reservoir with more solvent and attach it
to the spray gun.
Technical specifications:
Operating voltage: 230 V AC
Frequency: 50 Hz
Power: 800 W
Air pressure: 0.2 bar
Flow rate: 500 mL/min
Reservoir capacity: 0.6 L
Weight: 3 kg
Always wear a dust mask when working!
Always wear hearing protection when working!
Always wear eye protection when working!
Read all the safety instructions and guidelines!
8