Starting The Device - Aeromax WB-121 Wichtige Sicherheitshinweise

800-W LOW-PRESSURE PAINT SPRAYER
VISCOSITY TABLE
Material
Satin paint
Two-part paint
Clear varnish
Satin paint diluted in water
Car-engine lubricant
Glaze

STARTING THE DEVICE

2. Hold the spray-gun reservoir.
3. Adjust the air tube.
4. Press the switch to turn the device on
(Fig. 6). Now the device is ready to use.
6
Ink
Acid
Viscosity (DIN)
15-50
25-50
Not diluted
20-50
15-40
20-40
20-40
Not diluted
1. Attach the air hose. Connect the air hose
to the base unit with the pin (Fig. 4). Tighten
while turning. Then attach the other end of the
air hose to the spray gun.
SPRAYING HORIZONTALLY (Fig. 8)
Position the air tube towards the front.
SPRAYING OBJECTS
5. Fill the reservoir. Firmly attach the spray
gun.
6. Only set the device down on clean surfaces.