Important Safety Instructions - Aeromax WB-121 Wichtige Sicherheitshinweise

800-W LOW-PRESSURE PAINT SPRAYER
800-W LOW-PRESSURE PAINT SPRAYER (WB-121)

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electrical devices, basic precautions should always be taken, including the
following:
a) Read all the instructions before using the device.
b) To reduce the risk of injury, close supervision is needed when the device is used near children.
c) Only use attachments recommended or sold by the manufacturer.
d) To disconnect, turn the device off and then disconnect the plug from the power source.
e) Do not unplug the device by pulling on the power cable. To unplug it, grasp the plug, not the
cable.
f) Unplug the device from the power source when not in use and before servicing or cleaning it.
g) Do not point the paint roll or accessories at yourself.
h) The device is not a toy. Keep it away from children.
i) Unplug the device when it is not in use.
j) The power cable and plug should be undamaged. Replace any damaged parts immediately by
contacting an authorized technician or returning the unit to the service agent.
k) Never submerge the device in liquid.
l) Do not use hot water to rinse or clean the device.
m) The device should not be used in workplaces bound by EC explosion regulations.
n) If the power cable is damaged, it should be replaced by the manufacturer, service agent or
similarly qualified person in order to prevent hazards.
o) Use personal protective equipment. Always wear eye protection and hearing protection.
p) Do not use flammable liquids with the spray gun.
q) Do not clean the spray gun with flammable solvents.
r) Beware of any hazards presented by the liquid used with the spray gun, and consult the container
label or the information supplied by the manufacturer of the liquid, including requirements for the
use of personal protective equipment.
s) Do not use a liquid with the spray gun if you do not know the hazard it may present.
t) The electrical supply should be installed by an electrician and comply with IEC 364 standard. The
installation should include a fault-current protection switch that cuts the power when the fault current
exceeds 30 mA for more than 30 ms.
General Power Tool Safety Recommendations
WARNING: Read all safety warnings and instructions. Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the recommendations refers to mains-operated (corded) power tools and
battery-operated (cordless) power tools.
1. Work area safety.
a) Keep the work area clean and well lit. Working in cluttered and dark areas can lead to
accidents.
b) Do not operate the power tool in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while operating the power tool. Distractions can make you
lose control of the power tool.
3