Restore Factory Settings - HomeMatic IP HmIP-FSI16 Installations- Und Bedienungsanleitung

1x orange and
1 x green
lighting
7

Restore factory settings

The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the switch actuator,
please proceed as follows:
Press and hold down the system button (A) for at
•
least 4 seconds using a VDE screwdriver until the
LED (A) quickly starts flashing orange.
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
After the restart, you can again integrate your device into
your Homematic IP system.
Test display
Restore factory settings
Once the test display
has stopped, you can
continue.
45