Teaching-In - HomeMatic IP HmIP-FSI16 Installations- Und Bedienungsanleitung

• Fix the actuator to an appropriate surface-
mounting box (e.g. Abox 025 or Abox 040) (see
figure 3).
• Fix the actuator to the holding mandrel using the
fixing lug (B) (see figure 5).
• Close the surface-mounting box using the
corresponding cover.
• Switch the fuse of the power circuit on again to
activate the teach-in mode of the device (see
figure 6) (see "5.3 Teaching-in" on page 41).
5.3

Teaching-in

Read this entire section before starting the
teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, refer to the operating
manual of the Access Point.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2/CCU3. For detailed information, refer to the
Homematic IP User Guide, available for download
in the download area of www.homematic-ip.com.
Start-up
41