Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Please observe the hazard information in section
"2 Hazard information" on page 31 during
installation.
Permitted cable cross sections for connecting to the
switch actuator are:
rigid cable [mm
1.5 – 2.50
5.2
Installation
You can install the switch actuator
•
in a flush-mounting box or
•
in a surface-mounting box.
5.2.1
Installation with flush-mounting box
To install the device in a flush-mounting box, please
proceed as follows:
•
Switch off the fuse of the power circuit (see figure
2).
Connect the actuator to L (C) and N (E) to obtain
•
power supply (see fig. 3).
•
Route the switched phase (D) to the consumer
(see fig. 3).
•
Connect an external push-button or switch to
connecting terminal S1 (B) (see figure 3).
2
]
Flexible cable
without ferrule [mm
1.5 – 2.50
Start-up
2
]
39
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
